What is a multimeter? The way to use a multimeter?

What is a multimeter? The way to use a multimeter?  : -

What is a multimeter? the way to use a multimeter?  : -

Come, friends, today we'll know what's a multimeter.
What are the kinds of multimeters?
what's the function of multimeter?
The way to use multimeter?
Multimeter to electronic How the component is checked.
Analog Multimeter and Digital Multimeter Happens to understand about all of them.

Use and performance of multimeter  : -

If we talk then we'd like to know multimeter to see electronics components.
If necessary, we'll first understand the working of multimeter. By multimeter we will
Also electronic components like capacitors, registers, diodes, transistors, mosfets, etc.
Can check, along side Ac Volt, Dc Volt and Ampere and any circuit card Supply etc. are often checked, so come further during this post we'll mention multimeter intimately .
attempt to know.

 Function of multimeter  : -

 Use of multimeter is extremely important and necessary to see any circuit
 it's believed that this is often why we'd like to understand about its use. Of multimeter
 In technical language, wires are called (probes), by multimeter we've voltage, continuity etc.
 Can check So let's skills to see electronics's components from multimeter
 Will do

 we all know that a multimeter has two probes  : -

1. Red probe (+) is positive.

2. Black probe (-) is negative.

Multimeter are of two types  : -

1. Analog Multimeter (Needle)

2. Digital Multimeter (with display)

1. Analog Multimeter (Needle)  : -

2. Digital Multimeter ( with display)  : -

 

With multimeter, we check any circuit in two ways  : -

 1. Hot Testing (placing Power On within the circuit)

2. Cold Testing (placing Power Off within the circuit)

1. Hot Testing (placing Power On within the circuit)  : -

Tested by placing Power on ON in any component OR circuit by Hot Testing Goes which makes it a touch risky to see because even a touch inadvertence happened and therefore the circuit Can go bad. Therefore, take care while hot testing. But where hot
 the tactic of Hot Testing is to be used only testing is required. Because Where Hot Testing are going to be required, Cold Testing doesn't work, then Hot there Do the test itself.

2. Cold Testing (placing Power Off within the circuit)  : -

With Cold Testing, we will test the facility by turning off the facility in any component OR circuit Is done. This method is usually used. Which checks any circuit there's no risk in doing this because the circuit supplies are closed. in order that we will check it's easy and you ought to use Cold Testing the maximum amount as possible.

 Multimeter uses three stages of multimeter to see any electronic component.  : -

1. Shot

2. Value

3. Open

1. Shot  : -

Shortcode on checking any electronic component with an analog multimeter That is, both the probes (+, -) of the multimeter also are connected where both the ends are connected together. within the short position, the needle of the multimeter runs from the primary end to the top . Short key within the case of a digital multimeter, the sound of Beep comes when checked.
 Note  : - Multimeter will set the at Continuity.

2. Value  : -

On checking any component from the analog multimeter Multimeter Represents the component's value. Multimeter inside analog multimeter If the needle of the multimeter stops from the primary place to anywhere within the middle, then the position value it's called.

Note  : -    The worth of the component inside the display inside the digital multimeter

(Reading).

3. Open  : -

Multimeter, both analog and digital, just in case of short that's to mention , once we activate the multimeter and therefore the situation is that the same Hold on position.

 Through a Multimeter, we check any electronics circuit PCB or printed components like Capasitor, Coil, Resistance, Fuse, Transistor, Diode, Mosfat, Speaker, Mic, etc.