How to fix mobile charging connector? How to repair the mobile charging section? : -
What is the fuse,
What is the coil,
What is the nonpolar capacitor,
What is the ginner diode. And
What is the simboll of all these and
What is the charging IC along with it.
If all these components go bad, how can we check it and fix it,
so let's see.
Today we are going to talk about the charging section of mobile, how to repair the charging section in simple language.
Charging Section : -
Charger check : -
Charging Connector : -
Fuse (K / F) : -
Coil (L) : -
Capacitor : -
SMD capacitor (nonpolar capacitor) : -
If the coils are correct then the nonpolar capacitor is then placed to check the nonpolar capacitor by placing the multimeter in the buzzer (beep) to put the (+) Red wire of the multimeter into the ground and the second (-) Black wire to the first point of the nonpolar capacitor. If you keep it in the second point then you will hear the sound of a beep (one beep) and if you tell the reading on the other side, then if you are bad then you can put another.Diode : -
Charging IC / Ginner Diodes : -
If the nonpolar capacitor is also correct, then it is fitted with charging IC or ginner diode. If the charging IC is bad then change the charging IC and if the ginner diode is installed then we know that the ginner diode is one If you are giving readings from both sides of the ginner diode, or if you are telling the open, then the ginner diode can change it if it is bad.Direct charging : -
1. If this is not happening at all, then we can give direct charging. Ginner diode is required to give direct charging. We know how to apply a ginner diode to the ginner diode (+) (-). If it is placed near the charging connector then the (+) point of the charging connector and the (+) point of the ginner diode. Wire and connect the (-) point of the charging connector and (-) point of the battery connector (jumper).2. If we are placing the ginner diode near the battery connector then we will place the (jumper) in the (-) point of the ginner diode and add it to the (+) point of the battery connector so that the ginner diode is one and Voltage is coming from the charging connector, therefore, because the voltage is coming from the charging connector, so the (+) point of the ginner diode will be there and the (-) point will be in the battery connector.
It is also that the charging IC controls the charging section and also informs us whether the battery is charging if charging takes place, the charging is complete and the battery is lowered.
0 Comments